Watch the video for step by step instructions. Use LMA-T to connect to Hydro-X or Hydro-X Pro. Connect it into both lines, line 1 and 2 for light control and have control over both white or broadband light spectrum as...
DSV-1 is a low-voltage output module that can be addressed to be used as a temperature, humidity, CO2, or timer device module. You will have multiple voltage outputs options. The DSV-1 can output either 12 or 24 VDC up to .5...
The system uses a photocell sensor to monitor the light status by the Line1/Line2 setting. If the lights are on/off when they’re not supposed to, then the system will send you light alerts. You could set the Line2 channel to...
The 4RS-1 is a universal 4-outlet power expansion module. It can be used with any of TrolMaster’s “plug-in” style device modules to expand the number of devices that can be controlled by the Hydro-x. Connect a single 120-240 volt “trigger”...
TIPS: It is recommended to skip the FAN connection, and have the fan and compressor run together through DEHU terminal. regardless of the number of units connected. If the fan stays on when the compressor goes off, a lot of...
The Hydro-X could control LEDs with 0-10V Dimming by lighting adapter LMA-14. TrolMaster provides a ECS-2 cable set for the wiring from LMA-14 to the dimming leads. The ECS-2 connector has a positive and a negative ports for simple connection....
To connect your controller to your App, don’t forget to connect it to the Internet first. Hardwire your controller to your router directly for the most reliable connection. Check the connection symbol on the main screen to make sure the correct connection is built....
How to use LMA Adapters for multiple lights? Both the Hydro-X Controllers have 2 line lights giving the ability to control double the amount of each type of light (48 LEDs and 80 Ballasts). If you require running more than...
Welcome to MangoTech - US
You're visiting us from %country%, redirect to %redirect_store%?
